Publicité
CAUSE BATTERY EXPLOSION.
TO REDUCE RISK OF
A SPARK NEAR BATTERY:
a) Check polarity of battery terminals. POSITIVE (POS,
P, +) battery post usually has a larger diameter than
NEGATIVE (NEG, N, -) post.
b) Connect POSITIVE (RED) charger clip to POSITIVE (POS,
P, +) post of battery.
c) Position yourself and free end of cable as far away from
battery as possible – then connect NEGATIVE (BLACK)
charger clip to NEGATIVE (NEG, N, -) post of battery.
d) Do not face battery when making the final connection.
e) When disconnecting charger, always do so in reverse
sequence of connecting procedure and break first con-
nection while as far away from battery as practical.
f) A marine (boat) battery must be removed and charged
on shore. To charge it on board requires equipment spe-
cially designed for marine use.
IMPORTANT SAFETY
INFORMATION!
• Charge no other batteries than specified in TECHNICAL
INFORMATION.
• Check the charger cables prior to use. Ensure that no
cracks have occurred in the cables or in the bend protec-
50013552C MXS 5.0 NA, Manual, Print file 002.indd 5
All manuals and user guides at all-guides.com
• Ensure that the cabling does not jam or comes into contact
• Never charge a damaged battery.
• Never place the charger on top of the battery when
• Avoid covering the charger.
• All batteries fail sooner or later. A battery that fails dur-
• If power consumers like fitted alarms and navigation com-
• Always check that the charger has switched to STEP 7
• Batteries consume water during use and charging. For bat-
• This appliance is not designed for use by young children or
tion. A charger with damaged cables must be returned to
the retailer.
with hot surfaces or sharp edges.
charging.
ing charging is normally taken care of by the chargers
advanced control, but some rare errors in the battery could
still exist. Don't leave any battery during charging unat-
tended for a longer period of time.
puters are connected to the battery, the charging process
takes longer and may drain the battery.
before leaving the charger unattended and connected for
long periods. If the charger has not switched to STEP 7
within 50 hours, this is an indication of an error. Disconnect
the charger.
teries where water can be added, the water level should
be checked regularly. If the water level is low add distilled
water.
people who cannot read or understand the manual unless
they are under the supervision of a responsible person to
EN • 7
2016-11-21 15:01:25
Publicité
