Télécharger Imprimer la page

CTEK MXS 5.0 Mode D'emploi page 3

Masquer les pouces Voir aussi pour MXS 5.0:

Publicité

f) Be extra cautious to reduce risk of dropping a metal tool
onto battery. It might spark or short-circuit battery or
other electrical part that may cause explosion.
g) Remove personal metal items such as rings, bracelets,
necklaces, and watches when working with lead-acid
battery. A lead-acid battery can produce a short-circuit
current high enough to weld a ring or the like to metal,
causing a severe burn.
h) Use charger for charging a LEAD-ACID battery only. It is
not intended to supply power to a low voltage electrical
system other than in a starter-motor application. Do not
use battery charger for charging dry-cell batteries that
are commonly used with home appliances. These batter-
ies may burst and cause injury to persons and damage to
property.
i) NEVER charge a frozen battery.
PREPARING TO CHARGE
12.
a) If necessary to remove battery from vehicle to charge,
always remove grounded terminal from battery first.
Make sure all accessories in the vehicle are off, so as not
to cause an arc.
b) Be sure area around battery is well ventilated while bat-
tery is being charged.
c) Clean battery terminals. Be careful to keep corrosion
from coming in contact with eyes.
50013552C MXS 5.0 NA, Manual, Print file 002.indd 3
All manuals and user guides at all-guides.com
d) Add distilled water in each cell until battery acid reaches
e) Study all battery manufacturer's specific precautions
f) Determine voltage of battery by referring to car owner's
13.
a) Locate charger as far away from battery as DC cables
b) Never place charger directly above battery being
c) Never allow battery acid to drip on charger when read-
d) Do not operate charger in a closed-in area or restrict
e) Do not set a battery on top of charger.
level specified by battery manufacturer. Do not overfill.
For a battery without removable cell caps, such as valve
regulated lead acid batteries, carefully follow manufac-
turer's recharging instruction.
while charging and recommended rates of charge.
manual and make sure it matches output rating of battery
charger.
CHARGER LOCATION
permit.
charged; gases from battery will corrode and damage
charger.
ing electrolyte specific gravity or filling battery.
ventilation in any way.
 EN • 5
2016-11-21 15:01:25

Publicité

loading

Ce manuel est également adapté pour:

1090