LiftMaster LM55EVF Notice De Montage Et De Commande page 19

17. The running path cannot be programmed, is de-programmed
or is changing slowly:
• The programmed running path is too short. Programme a longer path
for testing purposes.
• A small plastic knob is factory-mounted on the chain that is running in
the rail. During the travel of the opener this little button must press
the small switch located on the drive head. If the path is too short
or the button was torn down by incorrect installation, it has to be xed
again. If the small switch is not pressed, the programming of the
opener is not possible.
• A mechanical fault at the door due to de ected joints or the chain ten-
sion on the drive is too loose.
18. Description of LEDs
LED1
• Flashes brie y: A radio signal is received. Once the remote control
is programmed it opens and closes the opener.
• Is constantly on for approx. 10 seconds: An additional remote can be
programmed or all remotes will be deleted.
LED2
• Is constantly on: as long as the opener runs.
• Flashes: opener is in programming mode, „OPEN" position has
already been programmed and opener is ready for position
„CLOSED".
LED3
• Flashes: opener is in programming mode and ready for „OPEN"
position
15
Speci cations
Input voltage
Max. pulling force
Nominal torque
Standby consumption
Input accessories
Motor
Type
Voltage
Noise level
Drive mechanism
Length of travel
Speed
Lighting
Safety
Electronically
Electrically
Limit switch adjustment
Dimensions
Length (overall)
Required clearance height
Suspended weight
Radio receiver
Memory
Operating frequency
Battery
Max. power of the
remote control
220-240 V 50/60 Hz
600 N
5.0 Nm
0,8 Watt
24 V / 300 mA
worm gear type
__
24 V
55 dB
2.63 m
10 cm /sec
LED 1W
automatic force adjustment
thermal fuse in transformer
manually
3.14 m
min. 35 mm
10 kg
16 remote controls
433 MHz, 868 MHz
3 V, type CR2032 (10A20-WH)
< 5 mW
Door dimensions and -weight
One piece doors
3500
max. width (mm)
max. height (mm) 2250
90
max. weight (kg)
Sectionaldoors
max. width (mm)
3500
max. height (mm)
2250
max. weight (kg) 90
16
Service parts / Warranty
Your statutory rights are not a ected by this manufacturer's warranty.
Please see www.liftmaster.eu/warranty for terms of warranty.
17
Accessory
(optional)
Always use Liftmaster accessories.
External products can cause malfunctions.
1. TX4UNIF/S 4-channel remote control
2. 128EV 2-channell wireless wall control
3. 747EV Keypad
4. 75EV Illuminated push button
5. G770E Safety photocells
6. EQL01EV External quick release
18
Declaration of conformity
The manual consists of these operating instructions and the
declaration of conformity.
en 09/09