LG WM2432HW Guide Du Propriétaire page 10

INSTALLATION INSTRUCTIONS
■ Level adjustment
Adjustable feet
• Leveling the washing machine properly prevents excessive
noise and vibration.
Install the appliance on a solid and level floor surface,
preferably in a corner of the room.
• If the floor is uneven, adjust the adjustable feet as required.
(Do not insert pieces of wood, etc. under the feet.)
NOTE: Extend the feet no more than necessary to level the
• Make sure that all four feet are stable and resting on the
floor and then check that the appliance is perfectly level
(Use a level).
• After the washer is level, tighten the lock nuts up against of
the base of the washer. All lock nuts must be tightened.
Lock nut
• It is critical to adjust the feet perfectly. This must be done
while the washer is spinning with a load. Use the wrench
(supplied) to adjust the feet until there is no vibration. Then
tighten the lock nuts to prevent further adjustment.
Adjustable feet
NOTE: If there are vibration and noise during the spin cycle,
Adjustable feet
✽
washer. The more the feet are extended, the more the
washer will vibrate.
re-check the leveling of the washer, adjust the feet as
required, and tighten the lock nuts securely to prevent
changes in adjustment.
Run the washer with a test load to make certain your
washer is properly leveled. Put approximately 6
pounds of laundry in the machine. Then, press
POWER, RINSE+SPIN, and START/PAUSE, in that
order. When the machine spins at high speed, verify
that it is stable. If not, adjust the feet accordingly.
Diagonal Check
When pushing down the edges of the washing machine top
plate diagonally, the machine should not move up and down at
all. (Please, check both directions.)
If the machine rocks when pushing the machine top plate
diagonally, adjust the feet again.
9