Technical Data - D+H KA 66-TW Notice Originale

Technical data

Type
Power supply
Nominal force
Nominal locking force
Lifetime
Duty cycle
Housing
Ingress protection
Temperature range
Fire stability
Nominal stroke length *
Additional functions *
* programmable with software SW-BSY+
Running speed and forces
Normal operation =
SHEV- fast running =
Clamping protection
In "CLOSE" direction the drive has an active
clamping protection for the main closing edge. With
an overload in the closing range 3 and 2 the drive
runs "OPEN" for 10 seconds, then drive "CLOSE"
again. If after three attempts a closing is not possible,
the drive remains in this position.
In addition, the drive has a passive clamping
protection. The closing speed in closure Range 2
and 1 is reduced to 5 mm/s.
Higher forces can occur on besides
closing edges. Danger of violent
pressure in handaccessible area.
8/20
KA 66-TW
KA 66/xxx-TW
24 VDC / ±15% / 2,0 A
2x 300 N
1000 N
>10 000 double strokes
30 % (with cycle time 10 minutes)
anodized aluminium
IP 32
(with covering stoppers delivered with bracket sets)
-5 ... +75°C
30 min / 300°C
see type plate
clamping protection activated (3 stroke repeatings), locking relief activated
2x 300** N, 11,8 mm/s =
"-HS" 12,2 mm/s =
(with tensile force (1/2 nominal load)
16,1 mm/s)
English
** + 20 % switch-off reserve
(temporary)
99.823.90 2.1/07/11