Publicité
Step 18
å
You have the option to fasten the Hutch to the 427795 or the 427798. This step shows the Hutch being
attached to the 427798.
å
With someone's help, carefully stand your unit upright, and place the Hutch centered onto the base unit.
å
There are no pre-drilled holes in the desk top/tops. Locate the center of each slotted hole in the BRACKET
CONNECTORS, and place a pencil mark on the back edge of the base unit top/tops. Drill a 1/8" hole on each
mark into the base unit top/tops.
å
Fasten the BRACKET CONNECTORS on the Hutch to the base unit top/tops. Use four SILVER 1" LARGE
HEAD SCREWS (102S).
Pro Tip: Lift with your
legs. And, you know,
your arms.
Page 24
Electric drill with 1/8" bit
SILVER 1" LARGE HEAD SCREW
(4 used in this step)
427799
Mark and drill four
1/8" holes into the
desk top/tops.
4 2 7
102S
7 9 8
www.sauder.com/commercial-office/service
Publicité
