Publicité
Les langues disponibles
Les langues disponibles
HOW TO REPLACE BULB:
1.
To prepare for bulb replacement, unplug unit and allow it to sit for three hours to
allow the electrical charge within the unit to dissipate.
2.
Remove the tray.
3.
Remove both screws securing grate panel.
4.
Lift up grate to access bulb.
5.
Wearing gloves, Gently tug on the bulb to remove.
6.
Replace bulb only with proper Coby replacement bulbs.
7.
Wearing gloves, insert replacement bulbs making sure they are properly seated into
the sockets that they were removed from.
8.
Gently apply pressure on bulbs until they snap into socket securely.
9.
Place grate plate back into position and fasten with screws.
10. If using base tray, slide back into place on bottom of unit.
11.
Plug in to test replaced bulb functions properly.
12.
Replaceable lamp, type 2G11 18W, Rated 18W for model
NOTE: If device fails to light after bulb replacement, unplug device, and following the
instructions above ensure that the bulb was correctly installed, and re-assemble unit.
Fig. 1
Page 8
(As indicated on Pg. 4)
(Fig. 2)
Fig. 2
NOTE: Bulb contains mercury, dispose of properly.
To order replacement bulbs, call 1 (855) 855-0294
(Fig. 1)
(Fig. 3)
Fig. 3
Publicité
