Expondo Wiesenfield WIE-FMO-175S Manuel D'utilisation page 60

3. Use guidelines
The machine is designed to mulch plant residues generated by field work,
viticulture, orchard work, and is also used to clean other agricultural, municipal or
infrastructural surfaces.
The user is liable for any damage resulting from unintended use of the device.
3.1. Assembly & Set-up
Torque Requirements
Refer to "Torque Values Chart for Common Bolt Sizes" to determine correct
torque values when tightening hardware.
Tractor Requirements
Tractor horsepower and hitch category should be within the range noted below.
Tractors outside the horsepower range must not be used. The lower 3-Point arms
must be stabilized to prevent side-to-side movement. Most tractors have sway
blocks or adjustable chains for this purpose.
Horsepower Rating: 50-70 HP
Hitch Type: 3-Point Cat. I
Rear PTO Speed: 540 RPM
Tractor Hook-up
Refer to Figure 1-2:
1. Be certain tractor draw bar does not interfere. Move draw bar ahead or
remove if required. Draw bar should also be checked for clearance when unit is
raised for the first time.
2. Remove all three clevis hitch pins.
3. Align ball swivels in the tractor's lower 3-Point arms with pin holes in the lower
hitch clevises of the mower. Insert hitch pins and secure with hair pin cotters.
4. Align the top center link with the center hitch clevis of the mower. Insert hitch
pin and secure with hair pin cotter.
5. With tractor's 3-Point controls, lift mower up 1 to 2 inches and then raise jack
stands fully up. Secure stands with jack pins and hair pin cotters.
6. Level mower by adjusting lower 3-Point arms and upper center link. Refer to
"Leveling the mower".