Télécharger Imprimer la page

MSW Motor Technics MWS-ETEH3000 Mode D'emploi page 23

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
Handling:
Place the device in its desired location.
Connect the plug to a suitable power source.
Set the temperature control knob (in the picture above) to the "MAX"
position and let the unit work at full power, thanks to which the unit will
heat the room more efficiently.
Use the knob on the right to set the blowing power (fan speed) - 3 speed
levels to choose from. The unit works if the knob is set to a position other
than "0".
If necessary, the temperature can be set to a lower temperature during
operation.
IMPORTANT: if the temperature of the environment reaches the set
temperature, the device will turn off, but the fan will continue to work. If
the temperature drops below the set value, the heating will start
automatically.
Before switching off the unit, set the temperature knob to the "MIN"
position (lowest temperature) and the fan speed to the slowest (one
position higher than "0) and let the unit run for a few minutes until it cools
down. Only after this time, set the fan knob to the "0" position.
IMPORTANT: the fan can start up automatically at any time to further cool
down the unit, even if the unit is turned off (the temperature is set to the
minimum and the fan knob is in the "0" position), provided that the plug
is connected to the power supply. For this reason, it is recommended to

Publicité

loading

Ce manuel est également adapté pour:

Mws-eteh5000