Electrolux ERB29233W Notice D'utilisation page 16

16 electrolux
3. Remove the spacer (m6) and move to the oth-
er side of the hinge pivot (m5).
4. Remove using a tool the cover (b1). Unscrew
the lower hinge pivot (b2) and the spacer (b3)
and place them on the opposite side.
5. Re-insert the cover (b1) on the opposite side.
b3
6. Remove the stoppers (1) and move to the oth-
er side of the doors.
1
7. Unscrew the upper hinge pivot (t1) and screw
it on the opposite side.
All manuals and user guides at all-guides.com
b1
b2
8. Remove the left-hand cover pin of the middle
hinge (m3,m4) and move to the other side.
9. Fit the pin of the middle hinge (m5) into the left-
hand hole of the lower door.
10. Re-insert the lower door on the lower hinge
pivot (b2).
11. Fit the upper door on the upper hinge pivot
(t1).
12. Re-insert the upper door on the middle hinge
pivot (m5) slightly tilting both doors.
13. Re-screw the middle hinge (m2). Do not forget
the plastic spacer (m1) inserted under the mid-
dle hinge. Make sure that the edges of the
doors run parallel to the side edge of the ap-
pliance.
14. Reposition, level the appliance, wait for at least
four hours and then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-
cialist will carry out the reversibility of the doors at
your cost.