Publicité
Les langues disponibles
Les langues disponibles
Installing the stainless steel handle
This appliance includes a stainless steel handle. To install the handle please follow the below
instructions:
1.
Pull away the door gasket in the area where the handle is to be installed on the left side as shown
below in Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
2.
Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver
until the handle sets both flush and secured tightly against the door frame. (DO NOT over tighten
as this will cause damage to the handle assembly).
3.
Replace the door gasket to its original position.
4.
If you choose not to use the handle supplied, simply follow step 1 to access the installation screws
and remove them and then place the two decorative plugs into the two holes separately. Continue
on to step 3 to replace the door gasket to its original position.
Illustration # 1
1.
Gasket
2.
Phillips Head Screw
Illustration # 2
3.
Phillips Head Screw Driver
4.
Handle
9
Publicité
