Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
~
WARNING
·
Read all instructions before using the appliance.
·
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous . . . even if they will "just sit in the garage a few days".
·
Before you throw away your old appliance: Take off the door. Leave the shelves
in place so that children may not easily climb inside.
·
Never allow children to operate, play with, or crawl inside the appliance.
·
Never clean appliance parts with flammable fluids. The fumes can create a fire
hazard or explosion.
·
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other appliance. The fumes can create a fire hazard or explosion.
·
Follow handling instructions carefully
·
This appliance may not be treated as regular household waste, it should be taken to
the appropriate waste collection point for recycling of electrical components. For
information on local waste collection points, contact your local waste removal agency
or governmental office.
Before using your appliance
- Remove the exterior and interior packing.
- Check to be sure you have all of the following parts:
Shelves ( 2 )
- Before connecting the appliance to the power source, let it stand upright for approximately 6 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
- Clean the interior surface with lukewarm water using a soft cloth.
- Install the handle on the left side of the door.
Installation of your appliance
- Two people should be used when moving the appliance
- This appliance is designed to be for free standing installation or built-in (fully recessed).
- Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level
your appliance, adjust the front levelling legs at the bottom of the appliance.
- Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.
- Avoid locating the unit in moist or wet areas.
- Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an authorized
Avanti Products service center.
Built-in cabinet instructions
This unit is designed for either built-in or free standing
installation. If you plan to use this unit in a built-in
application please follow the requirements shown to the
right.
~
-Save these instructions-
INSTALLATION INSTRUCTIONS
Model ARFSE55R3S
Stainless Steel Handle
7
To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:
Instruction Manual
Cabinet Opening Dimensions
Inches
Width
Depth
Height
Centimeters
24
61
26
66
35
89
Publicité
