SNOWJOE 24V-X2-13SS-CT Manuel D'utilisation page 9

Charging the Batteries
1. Press the push lock buttons on the batteries to pull them
out of the equipment (Fig. 1).
Fig. 1
Push lock button
2. Depending on your Snow Joe
how to recharge your lithium-ion battery will vary.
You may either insert your 24-volt battery into the
24VCHRG-QC Quick Charger (sold separately) or the
24VCHRG-DPC Dual Port Charger (sold separately)
(Figs. 2 – 3).
Fig. 2
Charging
red
24VCHRG-QC
Quick Charger
(Sold separately)
Fully
Charged
green
® + Sun Joe ® charger model,
Battery pack
Fig. 3
Charging
red
Fully
Charged
green
3. The battery indicator LEDs will illuminate one by one during
the charging process. Unplug the charger immediately when
the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual Port Charger (sold separately)
are also equipped with additional charging indicating lights
which will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from the
outlet first, then disconnect the charger from the battery.
m
WARNING!
The chargers do not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when you
notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
9
Battery pack
24VCHRG-DPC
Dual-Port Charger
(Sold separately)