SNOWJOE 24V-X2-13SS-CT Manuel D'utilisation page 12

3. Remove the screws, the washers from the drive wheel
(Fig. 13).
Fig. 13
4. Disassemble the right side cover by removing the four (4)
screws that hold it in place (Fig. 14).
Fig. 14
Right side cover
5. Use one hand to secure the auger; at the same time, use
the other hand to remove the auger assembly nut on the
right side. (Fig. 15).
Fig. 15
Auger
assembly nut
6. From the left side, remove the auger axle set (Fig. 16).
Fig. 16
Washer
Screw
7. Remove the old auger from the housing (Fig. 17).
Fig. 17
8. Install the replacement auger by following the above steps
in reverse order. (Fig. 18).
Fig. 18
Replacing the Belt
m
WARNING!
batteries before performing any maintenance task on your
cordless snow shovel.
1. Disassemble the left side cover by removing the four (4)
screws that hold it in place (Fig. 11).
2. To remove the old belt from the drive wheel, use one hand
to slowly turn the auger while using the other hand to lift the
belt (Fig. 19).
12
Auger
Make sure to turn off the unit and remove
Auger axle set