Publicité
P5080F
Installation Guide
Introduction
Directional Mounting Arrow
The Directional Mounting Arrow stamped into the top of the P5080F wall
mount indicates which edge is the top.
Wood Stud Installation
1
Minimum of 2 by 4 wood stud to be used
Minimum de 2 par 4 bois goujon pour être utilisé
You must secure the wall plate to three (3) wall studs with a minimum of
six (6) lag bolts (2 lag bolts for each stud found).
Vous devez assembler la sablière sur trois (3) rivets à bois avec un
minimum de six (6) tirefonds (2 tirefonds pour chaque rivet trouvé).
1) Use a stud finder to determine the center of wall studs in the vicinity of the
wall plate.
2) Use a pencil to mark the center of each of the wall studs.
2
1)
Place the wall plate against the wall in the desired viewing location.
2)
Use a pencil to mark the upper right mounting location along the center of
the wall stud.
3
Drill a "pilot hole" in the center of the upper right mark using a 1/4" drill bit and
power drill.
Only use a 1/4" drill bit when drilling the pilot holes.
N'utiliser qu'un foret de 1/4˝ lors du forage de guidage.
Page 4
X
X
X
Publicité
