Publicité
Attaching the Flat Panel to the Wall Plate
This section requires two people.
Cette section exige deux personnes.
Do not release your flat panel until you are certain that top and bottom hooks of both mounting
brackets are securely seated on the upper and lower mounting rails of the wall panel.
Éviter de relâcher votre écran plat jusqu'à
de haut et de bas de tous les deux supports de montage sont bien posés sur les rails
de montage hauts et bas de la sablière.
1) Raise the flat panel past the top and bottom mounting rails on the wall panel.
2) Slide the flat panel down slowly, keeping it close to the wall.
3) Engage the top and bottom mounting brackets to the rails of the wall plate.
Mounting Bracket Adjustment
Leveling Screw Adjustment
If your flat panel is tilted too far to one side, the leveling screws will allow you
compensate for this tilt by simply adjusting the screws with a screwdriver.
1) Loosen both locking screws.
2) Adjust the tilt of your flat panel.
3) Tighten both locking screws.
Caution!
It is possible to dislodge your flat panel while you level your flat panel.
Use extreme caution until you tighten the locking screws.
Attention !
C'est possible de retirer votre écran plat pendant son réglage. User d'une
extrême prudence jusqu'au moment du serrage des vis de blocage.
Locking Screw Adjustment
After you have finished leveling your flat panel, be sure to tighten the two (2) M6 x 250mm
locking screws, one on each mounting bracket.
Do not overtighten the locking screws.
Éviter de trop serrer les vis de blocage.
ce que vous vous assuriez que les crochets
P5080F
Installation Guide
M6 x 250mm
Leveling Screw
(1 per Bracket)
M6 x 250mm
Locking Screw
(1 per Bracket)
Page 11
Publicité
