Publicité
P5080F
Installation Guide
Lock-it™ Security Barrel Installation (Optional)
Optional security configurations include:
- PCB-CSL1 (sold separately)
- Padlock (Combination or Keyed; commercially
available)
Please read the following directions to install the security barrel:
1) Remove the locking screw from the mounting bracket.
2) Place the locking screw into and through the security barrel (see illustration below).
3) Re-insert the locking screw and security barrel into the mounting bracket.
4) Tighten the locking screw and security barrel until seated in the mounting tab.
Do not thread the locking screw any further once it is even with the
mounting tab (see illustration to the right). Threading the locking screw
any further will prevent you from safely attaching the flat panel to the
wall plate.
Éviter d'enfiler davantage la vis de réglage une fois qu'elle parvient au niveau
de la patte de fixation (voir illustration à droite). Le filetage excessif de la vis
de réglage au-delà de ce point gênera le fixage correct de l'écran plat sur la
sablière.
Do not overtighten the locking screw.
Éviter de trop serrer la vis de blocage.
Locking Screw
Attaching the Mounting Bracket to the Flat Panel
This section presumes that you have read and understood these sections:
●
Selecting the Proper Mounting Hardware
●
Universal Washer Installation
●
Universal Spacer Installation
1) Place your flat panel screen-side down on a soft, flat surface.
2) Identify the number and location of the thread inserts on the back of your
flat panel.
3) Aligning the holes on each mounting bracket with the thread inserts on the
back of our flat panel.
4) Secure each mounting bracket to your flat panel by inserting a minimum of
two (2) screw per bracket.
Do not overtighten the mounting hardware.
Éviter de trop serrer le dispositif de montage.
Page 10
Lock-It™ Security
Barrel
Mounting Tab
Publicité
