Télécharger Imprimer la page

Horizon Global 41955 Instructions D'installation page 4

Publicité

Les langues disponibles

Les langues disponibles

1. Remove Factory Bolts – Using a 22mm socket and 22mm wrench, remove (6) M15 hex bolts, flat washers, and hex nuts holding vehicle bumper (3 per
side), near rear of vehicle. See Figure 1.
Partially reinstall (1) bolt on each side, from outside toward the center through rearmost hole in vehicle bumper bracket and frame rail.
Install hitch – Raise hitch into position between the inside of frame rails and bumper brackets.
2a.
©2023 Horizon Global Americas Inc. - Printed in Mexico
Sheet 4 of 15
41955NP
5-4-23
Rev. A

Publicité

loading

Ce manuel est également adapté pour:

96955Cqt41955