Télécharger Imprimer la page

Horizon Global 41955 Instructions D'installation page 3

Publicité

Les langues disponibles

Les langues disponibles

Always wear SAFETY GLASSES
when installing hitch
Existing M15 Hex Bolt
New Orientation
Driver's side
(3) Places
1. Remove Factory Bolts – Using a 22mm socket and 22 mm wrench, remove (6) M15 hex bolts, flat washers, and hex nuts holding vehicle bumper (3 per
side), near rear of vehicle. See Figure 1.
Partially reinstall (1) bolt on each side, from outside toward the center through rearmost hole in vehicle bumper bracket and frame rail.
2. Install hitch – Raise hitch into position between the inside of frame rails and bumper brackets. Loosely install (6) factory M15 bolts as shown in Figure 1.
Apply blue thread locker to threads of all bolts. Install factory flat washers and hex nuts onto factory bolts, (6) places.
3. Torque fasteners - Tighten all factory M15 fasteners with torque wrench to 148 Lb.-Ft. (201 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which
has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety
specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2023 Horizon Global Americas Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 41955, 96955, CQT41955
Existing M15 Hex Bolt
Factory Orientation
Passenger's side
(3) Places
Figure 1
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Use existing vehicle fasteners
Frame rail
Vehicle Bumper
Bracket
Sheet 3 of 15
41955NP
Fastener Kit: 41955F
Fasteners
typical
both sides
Existing Flat Washer
(6) Places
Existing flange nut
(6) Places
Blue Thread
Locker is to be
used on ALL
Fasteners
5-4-23
Rev. A

Publicité

loading

Ce manuel est également adapté pour:

96955Cqt41955