Snel
Fast
When needed, the washing time can be decreased by pressing the fast button. It depends on
the selected program how much faster it will be.
Temperature
Temp./
When needed, the washing temperature can be adjusted by pressing the temperature button.
There are 6 settings: Cold - 20°C - 30°C - 40°C - 60°C - 70°C - 90°C.
Spinning rate
Toeren /
When needed, the spinning rate can be adjusted by pressing the spinning rate button.
There are 7 settings: 0 - 400 - 600 - 800 - 1000 - 1200 - 1400,
Functie
Functions
Push this button to select one or more additional functions, such as pre wash and extra rinse.
Prewash
Before the main washing cycle starts, the laundry will be extra washed to increase the
washing performance. Particularly suitable for heavily soiled laundry with stubborn
superficial stains.Note: Don't forget to also add detergent to compartment I.
Extra rinse
The laundry will undergo an extra rinse after selecting this function.
Stil
Silent
If the selected spinning rate is more than 800rpm, it will be reduced to 800rpm. The sound of
the controls will be automatically be canceled, when selecting this function.
Steam clean
SteamClean
The steam clean function can be added to the following programs: Cotton, Mix, Bed Linen and
Allergy. The steam clean function is added at the end of the program and helps to eliminate
bacteria and dust mites f.i..
Vlekken
Soil level
The soil level will automatically be set to medium. Check your laundry and adjust the soil level
if needed. When selecting the light soil level, the washing time can decrease, while choosing the
heavy soil level, the washing time can increase.
Adding laundry
It is possible to add or remove laundry during a washing cycle. After a certain period of time,
the appliance door can be opened if the water level and temperature are below a predefined
Was toevoegen
3 sec.
threshold. If the conditions below are met, then the electronic door lock is released and the
appliance door can be opened:
• water temperature in the drum has to be suitable;
• water level in the drum has to be below a certain value.
i
CAUTION!
When the drum is still rolling and there is a large amount of water with high temperature in the drum,
the state is unsafe and the door cannot be opened forcefully.
• Don't use the ADDING LAUNDRY function when the water level is over the edge of the inner drum or when
the water temperature is high.
In order to add or remove laundry from the drum during a washing cycle, proceed as follows:
1. Press the START PAUSE button for 3 seconds.
2. Wait until the drums stops rotating.
3. The door will unlock.
4. Open the door and add or remove the laundry.
5. Close the door and press the START PAUSE button. The washing cycle will resume.
43
English
•