Lindy 38387 Manuel Utilisateur page 6

User Manual
38389 Receiver Front and Rear
1. Power LED: Indicates Power
2. LINK LED: This will illuminate green when Transmitter and Receiver are connected, will flash when
connection is poor or not stable, will stay off where there is no connection.
3. VIDEO LED: This will flash when there is an active signal output, will stay off if there is no signal.
4. USB 2.0: USB 2.0 Type A ports, connect USB devices such as mouse, keyboard or flash drive.
5. SERVICE: USB Micro-B port for firmware updates.
6. DC 24V: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the transmitter
or receiver. When PoC function is enabled, this is only required at one side of the installation.
7. POC ON/OFF: DIP switch to turn ON/OFF the PoC function.
8. HDBT IN: Connect a compatible HDBaseT Transmitter using a single Cat.6 or above cable for all data
signals. Please do not connect to a network port.
9. Link Indicator LED:
- Illuminated Green: Link is Okay
- Flashing: Link is poor or not stable
- Not Illuminated: No Link
10. Data Signal Indicator LED:
- Illuminated Yellow: Signal is Okay
- Not Illuminated: No signal
11. HDMI OUT: Connect to a HDMI display.
12. AUDIO OUT: Phoenix block 3-way connection, analog audio output port.
13. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
14. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
15. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
Important! Before starting the installation, please ensure that all devices are powered off.
1. Connect an HDMI source device to the Transmitter unit using an HDMI or Type C cable.
2. Connect one end of the Cat.6 cable to the HDBaseT Out port on the Transmitter and the other end to
the HDBaseT In port of the Receiver. U/UTP or F/UTP installation cables are recommended. For cable
lengths please see the Specifications of this manual.
3. Use another HDMI cable to connect an HDMI display device to the HDMI output port on the Receiver
unit.
4. Please ensure that all the dip-switches are in the correct position, see above for details.
5. Plug the DC power supply into either the Transmitter or Receiver and switch on.
6. Power on the source device and display to complete the installation.
English