Lindy 38387 Manuel Utilisateur page 5

User Manual
Installation and Operation
38387-8 Transmitter Front and Rear
1. USB-C IN: Connect to a USB Type C source device, video up to 4K60 and USB 2.0 signals are
supported.
2. USB-C LED: This will illuminate green when the USB-C IN port is selected as input source.
3. HDMI IN: Connect to a HDMI source device.
4. HDMI LED: This will illuminate green when the HDMI IN port is selected as input source.
5. AUDIO IN: Connect to a 3.5mm Audio source for audio embedding.
6. TO PC: USB Type B Female port combined with HDMI IN port, connect to a USB port on a PC.
7. SOURCE: Button to switch between USB-C and HDMI inputs.
8. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
9. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
10. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
11. DC 24V: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the phoenix block
2-way connection. When PoC function is enabled, this is only required at one side of the installation.
12. POC ON/OFF: DIP switch to turn ON/OFF the PoC function.
13. HDBASET OUT: Connect a compatible HDBaseT receiver using a single Cat.6 or above cable for all
data signals. Please do not connect to a network port.
14. MODE STD/LRM: DIP switch to select STD or LRM mode.
- STD: Standard HDBaseT mode, supports 4K60 up to 90m distance.
- LRM: Long Reach HDBaseT mode, supports 4K30 up to 150m distance.
15. AUDIO IN LR/HDMI: DIP switch to select the Audio signal source:
- L/R: Will output the analog audio embedded from the AUDIO IN port.
- HDMI: Will output the de-embedded audio from the HDMI IN port.
16. EDID: DIP switches to set up the following presets:
- 00: Copy EDID from the display connected to the Receiver (default)
- 01: 4K30 4:4:4
- 10: 1080p60 4:4:4
- 11: 1200p60 4:4:4
English