Publicité
Les langues disponibles
Les langues disponibles
4. INSTALLATION
Installation 1: Wall installation of the set
1. Prepare the lamp, accessories and tools well, confirm the installation location and wire length.
(Figure ①)
2. Use the device to correctly measure the position of the hole, and drill 4 holes of Φ8mm with a depth
of 60mm on the
wall. (Figure ②)
3. Fix the expansion screws in the holes with free space, then fix the solar panel and LED lamp.
(Figure ③)
4. Open the silicone cover at the bottom of the lamp, connect the solar panel wire to the lamp, and
screw it tight. (Figure ④)
5. Adjust the solar panel and LED lamp to the correct position. (Figure ⑤)
Installation 2: Lay the projector on a flat surface only
Installation 3: Fix the projector only
Distribué par / Distribuito da / Distributed by / Vertrieben von NETELEC SRL FR - rue Philemon Laugier - 83400 Hyeres les Palmiers
Push the product stand aside and place it on a flat surface.
1- Please drill 2 Ø8mm holes on the wall with 88.5mm spacing.
2- Fix the dowels and expansion screws in the holes with free space
(do not lock on the bottom).
3- Spread the stand stand apart, align the hanging holes with the
screws and hang the lamp on the wall.
• The recommended suspension height is less than 2 meters.
Publicité
