Costway FP10378 Mode D'emploi page 4

● The cord supplied with
the heater has a plug
with two blades (live
and neutral) and one
round pin (ground). If a
3-slot receptacle is not
available, an adapter
MUST be used. The
adapter MUST be
properly grounded to
the outlet box (see
figure at right).
PREPARATION
This insert has front panel made of GLASS! ALWAYS use extreme
caution when handling glass. Failure to do so could result in personal
injury or property damage.
Remove all parts and hardware from the carton and place them on a clean,
soft, dry surface. Check the parts list to make sure nothing is missing.
Dispose of packaging materials properly. Please recycle whenever possible.
OPERATION
Read and understand this entire owner's manual, including all safety
information, before plugging in or using this product. Failure to do so
could result in electric shock, fire, serious injury, or death.
Power
Make sure the ON/OFF switch, located on the control panel, is in the OFF
position. Plug the power cord into a 120 Volt 15 Amp grounded outlet (see
IMPORTANT SAFETY INFORMATION). Make sure the outlet is in good
condition and that the plug is not loose. NEVER exceed the maximum
amperage for the circuit. DO NOT plug other appliances into the same circuit.
Thermostat
This heater is equipped with a Thermostat. Should the ambient temperature
exceeds/lower than the set temperature, the heater will automatically turn
OFF/ON.
06
Grounding Pin
Adapter
Metal Grounding Screw
Control Panel and Remote
Remote control
Control panel/Remote control Operation
BUTTON FUNCTION
ON: Enables control panel
functions and remote control.
Turn on flame effect.
OFF: Disables control panel
functions and remote control.
Turn off flame effect.
FLAME button: Control the
flame color and brightness
level.
HEATER button: Control the
temperature output mode.
When fireplace is turning on,
keep pressing for 5 seconds
to select the desired
temperature setting.
ACTION&INDICATION
1. Press once. Indicator light
turns on. Power turns on. All
functions enabled. 1500W
heater turns on and blows
warm air.
1. Press once. Flame color
gets changing.
2. Keep pressing for 5
seconds the flame brightness
gets changing.
1. Press once. Indicator lights
up. 750W heater turns on and
blows warm air.
2. Press again. 1500W heater
turns on and blows warm air.
3. Press third time. Heaters
turn off.
07