Publicité
Les langues disponibles
Les langues disponibles
led WoRklIGHT (fIG. f)
There is a worklight (5) located just above the
trigger switch (1). The worklight will be activated
when the trigger switch is squeezed.
NOTE: The worklight is for lighting the immediate
work surface and is not intended to be used as a
flashlight.
QuIck ReleASe cHuck (fIG. G)
NoTe: The chuck accepts 1/4 inch (6.35 mm) hex
accessories only.
WARNING:
off (center) position and remove battery pack before
changing accessories.
cAuTIoN:
Non-impact accessories may break and cause a
hazardous condition. Inspect accessories prior to
use to ensure that they contain no cracks.
To install an accessory, firmly insert the
accessory completely into the quick release chuck
(4) until an audible click is heard and verify the
accessory is locked in place by tugging on it.
To remove an accessory, pull the chuck collar
(3) away from the front of the tool, remove the
accessory and release the collar.
oN BoARd BIT SToRAGe
A bit storage holder (6) is built-in to the area on the
side of the battery.
Problem
• Unit will not start.
• Battery pack will not
charge.
• Unit shuts off abruptly.
For assistance with your product, visit our website at www.bostitch.com for a list of service
centers, or call the Bostitch Customer Care Center at (888) 848-5175.
Place the switch in the locked
Use only impact accessories.
TRouBleSHooTING
Possible cause
• Battery pack not installed
properly.
• Battery pack not charged.
• Battery pack not inserted into • Insert battery pack into
charger.
• Charger not plugged in.
• Surrounding air temperature • Move charger and battery
too hot or too cold.
• Battery pack has reached its • Allow battery pack to cool
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
F
5
G
Possible Solution
• Check battery pack
installation.
• Check battery pack charging
requirements.
charger until green LED appears.
• Plug charger into a working
outlet. Refer to "Important Charging
Notes" for more details.
pack to a surrounding air temperature of
above 40 degrees F (4.5°C) or below
105 degrees F (+40.5°C).
down.
• Place on charger and
allow to charge.
9
3
Publicité
