Publicité
Les langues disponibles
Les langues disponibles
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your local
service center.
4. The battery pack should be recharged when
it fails to produce sufficient power on jobs which
were easily done previously. DO NOT CONTINUE
to use under these conditions. Follow the charging
procedure. You may also charge a partially used
pack whenever you desire with no adverse affect on
the battery pack.
INSTAllING ANd ReMovING THe BATTeRy
PAck fRoM THe Tool
WARNING:
engaged to prevent switch actuation before removing
or installing battery.
To INSTAll BATTeRy PAck: Insert battery pack
into tool until an audible click is heard as shown in
figure B. Make sure battery pack is fully seated and
fully latched into position.
To ReMove BATTeRy PAck: Depress the battery
release button as shown in figure c and pull battery
pack out of tool.
oPeRATING INSTRucTIoNS
vARIABle SPeed TRIGGeR SWITcH (fIG. d)
To turn the tool on, squeeze the trigger switch (1).
To turn the tool off, release the trigger switch. Your
tool is equipped with a brake. The chuck will stop
as soon as the trigger switch is fully released. The
variable speed switch enables you to select the best
speed for a particular application. The more you
squeeze the trigger, the faster the tool will operate.
For maximum tool life, use variable speed only for
starting holes or fasteners.
NoTe: Continuous use in variable speed range is
not recommended. It may damage the switch and
should be avoided.
foRWARd/ReveRSe coNTRol BuTToN (fIG. e)
A forward/reverse control button (2) determines
the direction of the tool and also serves as a lock
off button. To select forward rotation, release the
trigger switch and depress the forward/reverse
control button on the right side of the tool. To select
reverse, depress the forward/reverse control button
on the left side of the tool. The center position of
the control button locks the tool in the OFF position.
When changing the position of the control button, be
sure the trigger is released.
NoTe: The first time the tool is run after changing
the direction of rotation, you may hear a click on start up. This and the impacting noise
that the tool makes is normal and does not indicate a problem.
Make certain the lock-off button is
B
C
D
E
8
1
2
Publicité
