REED INSTRUMENTS ST-612 Manuel D'utilisation page 6

Battery Replacement
WARnIng: To avoid possible electrical shock, disconnect the thermo-
couple connectors from the thermometer before removing the cover.
The battery symbol
9V battery needs to be replaced.
1. Turn the meter off and disconnect the temperature probe.
2. Remove the rubber holster that surrounds the entire meter by pulling it
over the top of the meter.
3. Remove the small Phillips head screw on the rear of the meter.
4. Open the battery compartment and replace the 9V battery.
5. Re-assemble the meter before operating.
For service (repairs or calibration) on this or any other REED product or
information on other REED products, contact REED Instruments at info@
reedinstruments.com.
appears on the lower right of the LCD when the
reedinstruments
www
com
6