Symptom
Possible Cause
"Timed On"
You are using the Remote Turn-On feature
indicator on front
(Same as Switched) and haven't plugged
panel is Off.
the plug into the component you wish to use
to activate the Remote Turn-On.
The component remote control you are using
to power the Remote turn-on has a dead battery.
The component you wish to use to activate
the Remote Turn-On isn't plugged into a
properly grounded 120 volt (nominal) outlet.
Video picture
The incoming video signal is not
has rolling bars
properly grounded.
or ghosting.
The PowerCenter
The PowerCenter protection circuitry has
is emitting a loud
sacrificed itself to protect connected equipment
buzzing alarm.
from a catastrophic surge.
TROUBLESHOOTING
Remedy
• Plug the plug into component you wish
to use to activate the Remote Turn-On.
• Replace the battery powering
the component remote control.
• Plug the component into a properly
grounded 120 volt (nominal) outlet.
• Contact your cable or satellite provider
to correct your installation.
• The PowerCenter must be replaced.
See the Warranty Information section
for important details.
17