Philips Sonicare HX3671/13 Mode D'emploi page 13

EasyStart
Cleaning
This Philips Sonicare model comes with the EasyStart
feature activated. The EasyStart feature gently
increases the power over the first 14 brushings to help
you get used to the brushing with the Philips Sonicare.
Activating or Deactivating EasyStart
Place the handle on the plugged-in charger.
1
2 Press and hold the power on/off button while the
handle remains on the charger.
3 Keep the power on/off button pressed until you
hear a single short beep (after 3 seconds).
4 Release the power on/off button.
5 After you release the power on/off button, you'll
hear three tones.
- Triple tone of low-med-high means the EasyStart
feature has been activated.
- Triple tone of high-med-low means the EasyStart
feature has been deactivated.
You should clean your Philips Sonicare toothbrush
regularly to remove toothpaste and other residue.
Failure to clean your Philips Sonicare toothbrush may
result in an unhygienic product and damage to it may
occur.
Warning: Do not clean product or accessories
with sharp objects or in dishwasher, microwave,
with chemicals or in boiling hot water
Toothbrush handle
Remove the brush head and rinse the metal shaft
1
area with warm water. Make sure you remove any
residual toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove
excess water.
13
English