Publicité
Les langues disponibles
Les langues disponibles
BEFORE YOU BEGIN
Read this manual carefully before installing or
servicing this equipment. Improper installation,
servicing, or maintenance will cause death,
injury, or property damage. Check the minimum
required safe distances from combustibles given
on the outside of each burner box to make sure
that the product is suitable for your application.
The minimum required safe distances from
combustibles is also found on page 8 of this
manual. Installer must be a licensed contractor or
representative. After the installation is complete,
check product operation as provided in these
instructions.
UNPACKING THE HEATER
Manpower Requirements
To prevent personal injury and damage to the
heater, two persons will be required to remove
the heater from the carton. Both ends of the
heater should be lifted from the carton at the
same time. The burner box should be lifted by
gripping the bottom of the box. The reflector
end of the heater should be lifted using the rear
moveable hanger.
Safety
Thin sheet metal parts, such as the reflector
portion of the heater and the various venting
components, have sharp edges. To prevent
injury, the use of work gloves is recommended.
The use of gloves will also prevent the transfer
of body oils from the hands to the surface of the
reflector.
INTRODUCTION
About The Heater
The 45GSP is a factory-assembled, gas fired, low-
intensity heating system. The system has been
designed for easy installation and will provide
years of economical operation and trouble-free
service. Not only is infrared heat efficient, it also
provides the most comfortable conditions in open
areas, such as workshops.
Gas-Fired means it uses clean-burning Natural
or LP gas. Low-Intensity means that the radiant
surface of the hear exchanger tube does
not glow red. Instead, it operates at a lower
temperature (less than 1000°F) and radiates
energy at a lower intensity per square foot of
radiating surface. The lower temperature and
Gas-Fired Low-Intensity Infrared Heater
intensity levels are within a range that is most
effective in establishing and maintaining personal
comfort levels. An aluminum reflector directs the
radiant energy downward to the occupied area.
Radiant refers to the energy radiated by the
tube heater. Because the energy is in the form
of infrared rays, it does not directly heat the air.
Instead, the rays heat objects such as the floor,
cars, machines and people. The warm objects,
in turn, heat the air. These combined features
are the key to the exceptional comfort and fuel
efficiency provided by the tube heater.
Available Accessories
F102848
Category I Vertical Vent Kit
Category III Horizontal Stainless
F102860
Steel Vent Kit
F102859
Decorative Egg Crate Kit
F102834
Install Kit
10371
24V Thermostat
3
Operating Instructions and Owner's Manual
Publicité
