Publicité
Les langues disponibles
Les langues disponibles
If you remove the blade to sharpen or replace it, you will
need a torque wrench to tighten the bolt. Always wear
gloves when handling the blade.
• Remove the bolt with a drive socket. Use a wood block to
prevent the blade from rotating when removing the bolt.
Then remove the blade;
• Install the blade using the blade bolt and special
washers. Make sure to install the special washers with
the concave side facing the blade and the convex side
facing the bolt;
• Tighten the bolt with a torque wrench. Use a wood block
to prevent the blade from rotating when tightening the
bolt.
Wash the grass bag with a garden hose and let it dry
completely before using it again. Using the grass bag wet
will cause it to clog quickly.
Replacement:
• Remove the plastic clips, remove the grass bag's frame;
• Insert the frame into the new bag, and secure with the
plastic clips.
Dirty air filters reduce engine power, increase fuel
consumption and make start-ups more difficult.
Check and clean the air filter in warm soapy water. Dry
completely before reinstalling.
The use of a dirty filter will restrict the air flow in the
carburetor affecting the performance of the lawnmower.
If damaged or shrunk, replace with a new one.
1. Remove the cover by pressing the tabs;
2. Remove the filter;
3. Check the filter for damage and replace if necessary;
4. Clean the filter by tapping several times on a hard
surface to remove dirt, or using a compressor; never try
to brush the filter as this may damage it;
5. Clean dirt from the inside of the filter housing using a
damp cloth;
6. Reinstall the filter in the housing and place the cover.
Always check the oil level with the machine switched off.
• Remove the cap from the oil tank and clean the dipstick;
• Insert the dipstick into the oil filler neck, but do not
screw it in;
• Check the oil level indicated on the dipstick;
• If you are near the bottom level, fill up to the indicated
level. Do not overfill;
• Fit the tank cap, making sure it is securely fastened.
Drain the oil while the engine is warm. Hot oil drains faster
and completely.
• Clean the oil filling area and then remove the tank cap;
• Place an oil drain pan next to the lawnmower to catch
the used oil, then tilt the machine to the right side. The
used oil will drain through the filler tube. Allow to drain
completely;
• Fill with the recommended oil (15W40). Do not overfill.
Allow a few minutes for the oil to settle and then check
that it is at the desired level.
If the clutch lever is loose, you must
turn the cable adjustment nut to
tighten.
If the brake lever is loose, you must turn the cable
adjustment nut to tighten.
Brake cable
adjustment
Clutch/traction cable
adjustment
Publicité
