sanindusa SAFIRA Notice De Montage page 9

1 3
3 6
6
Sanindusa S.A. reserva o direito de fazer alterações técnicas sem aviso prévio.
Sanindusa S.A. reserva el derecho de hacer alteraciones técnicas sin previo aviso.
Step 3 - Fixing Panel and Door to Wall Profiles
1. Centre the Door and Inline panel between the Wall Profiles.
• NOTE: A minimum of 6mm is required between the Inline Panel/Door and Wall Profiles for fixing.
2. Make sure the Inline Panel and Door are completely vertical using a spirit level.
• Prior to drilling/screwing the Inline Panel and Door refer to the Door installation guide to understand
the Door fitting and adjustment requirements.
3. Drill through the Wall Profile into the Panel vertical with the 2.5mm drill bit, make sure that the Inline Panel
and Door remain completely vertical during this procedure.
• You will need the assistance of someone when doing this procedure.
4. Fit the bases on the screws and fasten the Wall Profile and Inline Panel together, push fit the Cover Caps.
• It may be beneficial to apply some pressure to the Door and Inline Panel assembly and check the
door operation prior to fixing the door side.
1
Equal
6mm Minimum
Step 4 - Bracing
1. Measure the distance from the back wall to the outside face of the Inline Panel Glass.
2. Deduct that measurement from 1040mm, shorten the Brace Bar by the new amount (see *Example above).
3. Place the Bracing Assembly over the glass and up to the back wall (place the bracing close to the door for
the best stability). Use a Spirit level to keep it level.
4. With a pencil mark the wall through the screw holes in the Wall Bracket.
5. Remove the Bracing and drill the holes using a 6mm Masonry Drill (not supplied) and fit the Wall Plugs.
6. Replace the Bracing Assembly on to the Panel Glass and secure the Wall Bracket to the Back Wall.
7. Place the plastic spacer between the Glass and Glass Bracket at the front and tighten the Set Screw.
8. Tighten all screws.
• There is 10mm of adjustment in the Brace Bar assembly to allow for correct adjustment.
• The Brace Bar must be level, use a Spirit Level and ensure the bubble is in the middle of the two
lines.
• The panel must be vertically level, use a Spirit Level and adjust the bracing to achieve this.
NOTE: The Straight Section of the Brace Bar assembly may need shortening, if so use a hacksaw or similar.
It is IMPORTANT that it is shortened at the Wall Cup end - be sure to remove all burrs and sharp edges.
4
7
Sanindusa S.A. reserves the right to introduce technical improvements without previous notice.
3
Given Dimension
Wall to outside of glass
Reduce Brace Bar by (*1040-878=)
Sanindusa S.A. si reserva il diritto di effettuarre cambiamenti tecnici sensa preaviso.
4
9mm
Screw
Brace Bar (*Example only)
1040mm
*878mm
*162mm
Cut at this end
Sanindusa S.A. réserve le droit de faire des altérations techniques sans information prealable.
3
Equal
Cover
Base
4