sanindusa SAFIRA Notice De Montage page 12

Problem
Leaking
Enclosure Alignment
Door not Operating
Smoothly
Some important information to help you Maintain your product.
The following information is all you need to keep your product looking new.
Clean your product using a mild detergent diluted in water and then polished off using a soft cloth.
If you live in a hard water area, periodically clean your product using a 50/50 solution of white vinegar and water. The solution should be left on
the enclosure for approximately 5 minutes then rinsed off using warm water. This method of cleaning should remove lime scale residue.
Simple Maintenance
Our products are generally maintenance free, however it may be necessary to lubricate wheel assemblies and other moving parts from time to
time.
It is strongly recommended that a quality silicone spray is used.
A list of Don't's:
1. Don't use acidic based products which are unsuitable for cleaning enamel surfaces.
2. Don't use abrasive cleaners or cleaners using bleach or solvents, these products will adversely affect the finish of the aluminium profiles.
3. Don't use scouring pads, powder or any sharp instruments when cleaning the enclosure.
Should you experience any problems during installation please refer to the
Trouble Shooting Guide or contact Customer Relations on: +(351) 234 940 250
Sanindusa S.A. reserva o direito de fazer alterações técnicas sem aviso prévio.
Sanindusa S.A. reserva el derecho de hacer alteraciones técnicas sin previo aviso.
Trouble Shooting Guide
Solution
1. Check the tray has been sealed correctly prior to installation of the enclosure (Step 1 in the
Door Instructions).
2. Check the inside gap has been sealed correctly between the tray and wall profiles (Step 2
in the Door Instructions and Step 1 in these Instructions).
3. Check that the base of the enclosure is sealed to the tray on the outside only (Step 5).
4. Check to see if both wall profiles have been sealed vertically inside and outside where
they meet the tiled wall (Step 5).
5. Check that the base of the enclosure hasn't been sealed to the top of the tray on the inside
of the cubicle.(Step 5).
IMPORTANT: This enclosure should be water tested conforming to BS EN 14428
1. Check that the enclosure is fitted onto a tiled wall or a similar sealed surface (Step 1 in the
Door Instructions).
2. Check that the wall profiles have been fitted 10mm from the front outside edge of the tray
(Step 2 in the Door Instructions).
3. Check that the wall profiles have been fitted completely vertical (the bubble must be in the
centre of the two lines on a spirit level - Step 2 in the Door Instructions).
4. Check the enclosure is completely vertical and level (Step 1 in the Door Instructions).
1. Check that the tray is completely level (the bubble must be in the centre of the two lines
on a spirit level).
2. Check that the wall profiles have been fitted completely vertical (the bubble must be in the
centre of the two lines on a spirit level).
Sanindusa S.A. reserves the right to introduce technical improvements without previous notice. Sanindusa S.A. réserve le droit de faire des altérations techniques sans information prealable.
Sanindusa S.A. si reserva il diritto di effettuarre cambiamenti tecnici sensa preaviso.