Black & Decker CS1518 Mode D'emploi page 9

other unstable surface. You may lose
control of saw causing severe injury.
• keep the chain saw running at full
speed the entire time you are cutting.
• allow the chain to cut for you. Exert
only light pressure. Do not put pressure
on chain saw at end of cut.
on / off
• Always be sure of your footing and grip the
chain saw firmly with both hands with the
thumb and fingers encircling both handles.
• To turn the tool ON, depress the lock off
button (2) and squeeze the trigger switch
(1) as shown in figure k. (Once the tool is
running you can release the lock off button.)
• To turn the tool OFF, release the trigger switch.
k
SeTTInG THe cHaIn Brake
Your chain saw is equipped with a motor
chain braking system which will stop the
chain quickly in case of kickback.
• Make sure the tool is unplugged.
• Pull the chain brake / front hand guard
(3) back into the "set" position as shown
in figure l.
• The tool is now ready to use.
noTe: In the event of kickback, your left
hand will come in contact with the front
guard, pushing it forward, toward the
workpiece. This will stop the tool immediately.
l
TeSTInG THe cHaIn Brake
Test the chain brake before every use to
make sure it operates correctly.
• Place the tool on a firm surface. Make sure
the saw chain (5) is clear of the ground.
• Grip the tool firmly with both hands and
turn the chain saw on .
• Rotate your left hand forward around the
front handle so the back of your hand
2
1
2
comes in contact with the Chain brake /
front hand guard (3) and push it forward,
toward the workpiece. The saw chain
should stop immediately.
noTe: If saw does not stop immediately,
stop use of tool and bring it to a service
center nearest you.
warnInG: Make sure to set chain brake
before cutting.
coMMon cuTTInG TecHnIqueS
felling
Felling is the process of cutting down a tree.
Be sure battery is fully charged before felling
a tree so you can finish on a single charge.
Do not fell trees in high wind conditions.
warnInG: Felling can result in injury. It
should only be performed by a trained person.
• (figure M) A retreat path should be
planned and cleared as necessary before
cuts are started. The retreat path should
extend back and diagonally to the rear of
the expected line of fall.
• Before felling is started, consider the
natural lean of the tree, the location of
larger branches and the wind direction to
judge which way the tree will fall. Have
wedges (wood, plastic or aluminum)
and a heavy mallet handy.
Remove dirt, stones, loose bark, nails,
staples, and wire from the tree where the
felling cuts are to be made.
M
RETREAT
45°
• (figure n) Notching Undercut - Make
the notch 1/3 of the diameter of the tree,
perpendicular to the direction of the fall.
Make the lower horizontal notching cut
first. This will help to avoid pinching of
either the saw chain or the guide bar
when the second notch is being made.
n
2 (5cm)
DIRECTION
INCHES
OF FALL
NOTCH
9
DIRECTION
OF
FALL
TREE
FELLING BACK
CUT
2 (5cm)
INCHES
HINGE