Extension Cord - Festool SYSLITE DUO Guide D'utilisation

Suspend
from wall [6]
Use wall peg [2-1] on rear side of device. Place on
nail or screw head which protrudes from a wall.
6
by rope [7]
Device can be suspended from a rope via the guid-
ing groove [7-1] located on handhold.
7
7-7/8"
If an extension cord is required, it must have suffi-
cient cross-section to prevent overheating or an ex-
cessive drop in voltage. An excessive drop in voltage
reduces the output and can lead to failure of the
motor. The table below shows you the correct cord
~1/8 in.
diameter as a function of the cord length for this
power tool.
Total extension cord
length (feet)
Cable size (AWG)
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. Instead,
use one long one.
The lower the AWG number, the stronger the
cord.
min.
33 lb.
7-1

Extension Cord

25 50
16 16
7-7/8"
100 150
16 16
9