POLTI Vaporetto EASY Instructions page 7

disposal helps prevent negative impact on the
environment and human health and promotes
recycling of the materials making up the product.
For more information on available collection faci-
lities, contact your local waste collection service
or the shop where you bought this appliance.
IMPORTANT
Before leaving our factory all our products are ri-
gorously tested. Your Vaporetto may contain so-
me residual water in the boiler from the factory
testing.
PREPARATION FOR USE
• Unscrew the safety cap (A) by pressing and
holding (fig. 1).
• Fill the boiler with up to 6,5 fl oz (200 ml) of wa-
ter, using the jug (10) (fig.2).
It is a good idea to check that the boiler is
empty before filling it.
WARNING: never exceed the maximum boi-
ler fill level of 6,5 fl oz (200 ml); always use
the jug supplied.
• Carefully screw the cap back in fully.
Ensure that the safety cap (A) is correctly fa-
stened. If not, steam could escape from the
opening.
USE
• Plug the power cable (D) into a suitable socket
with an earth connection.
• The "Steam Ready" lamp (C) will turn on.
Wait for the steam ready lamp (C) to go out
(approx. 5 minutes). Your appliance is now
ready for use.
• To supply steam, simply press the steam re-
quest lever (B) (fig.3).
• The first time it is used, drops of water may
leak out. This is due to an imperfect thermal
stabilisation within the flex. We therefore re-
commend directing the first jet of steam onto a
cloth, until a uniform jet is obtained.
NOTE: the steam ready lamp (C) turns on and
off during use. This indicates that the electric re-
sistance is operating to keep constant pressure
and is therefore quite normal.
All manuals and user guides at all-guides.com
VAPORETTO EASY
IMPORTANT:
• During use, do not tilt the appliance more than
45°. If necessary, use the flex (1) keeping the
product horizontal.
ATTENTION: if pressing the steam request lever
(B) when the appliance is still pressurised, even
if off and disconnected from the mains, steam
may in any case be released. As such, before
turning the appliance off and putting it away,
please first press the steam request lever (B) un-
til the steam flow ceases.
"WATER OUT"
When no more steam comes out of the applian-
ce, do as follows:
• Disconnect the power supply cable (D) from
the mains.
• Act on the steam request lever (B) until steam
flow ceases.
• Wait for a few minutes to allow the generator
boiler to cool down.
• Unscrew the safety cap (A) by pressing and
holding (fig. 1).
• When cool, proceed to carefully refill the boiler
as described in "Preparation for Use" section.
If refilling the generator when not completely
cooled, we recommend that you then CARE-
FULLY pour only very small quantities of water
at each pouring, so as to avoid spitting from the
boiler. Cover exposed skin whilst filling.
5