Publicité
Les langues disponibles
Les langues disponibles
6. If ignition does occur within 5 seconds, turn burner control knob to "OFF",
wait 5 minutes for the gas to clear and repeat the lighting procedure. If the
burner still will not light, refer to the troubleshooting Section.
7. Once the appliance is lit, the flame height can be changed by adjusting
the burner control knob between the "High" and "Low".
8. Always check burner flames periodically to ensure proper operation.
Flames should be mostly yellow with some blue for best performance. (See
diagram)
9. Inspect the burner every time before use, if it is evident that the burner is
damaged or the burner can not light, please contact the manufactory to get
the appliance to replace it.
Improper lighting procedure will cause injury or damage
If the burner does not ignite with the burner control valve open, gas
will continue to flow out of the burner and could accidentally ignite
causing injury or property damage.
USING A LONG MATCH OR LIGHTER
1 Connect propane (LP)cylinder (see above pages).
2 Before lighting, move the lava rocks with a small shovel to allow access to
the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are
completely cooled.
3 Locate the burner control knob and make sure that it is in the "OFF"
position.
4 Wearing heat resistant gloves, position a long-lit match or lit long-neck
lighter close to the burner ports. DO NOT lean over the burner while lighting.
5 Push and turn burner control knob to the "LOW" position. The burner
should lit within5 seconds.
6 If ignition does occur within 5seconds, turn the burner control knob
to"OFF", wait 5 minutes for the gas to clear, and repeat the lighting
procedure. If the burner still will not light, refer to the troubleshooting section.
7 Flame height can be changed by adjusting the burner control knob
between the "LOW" and "HIGH" positions.
8 Always check burner flames periodically to ensure proper operation.
Flames should be mostly yellow with some blue for best performance.
22
10 inches
25cm
1 inch
2.5cm
TO EXTINGUISH
1. Push and turn the burner control knob to the "OFF" position.
2. Close the LP tank valve.
3. Disconnect the regulator from the LP tank to close the gas supply when
not in use.
4. Make sure that the unit is completely cooled before touching any of the
components or putting on the cover.
ROUTINE CARE
. Keep your appliance free and clear from combustible materials.
. Visually inspect burner for obstructions, keep an enclosure free and clear
from debris.
. After the burner and lava rocks are completely cooled down, use a soft
brush to get rid of the mild stains of dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
. Stubborn stains, discoloration, and possibly rust pitting can occur from
exposure to harsh outdoor conditions.
. Be careful not to let any powder or solvent come in contact with painted or
plastic components as damage may occur.
MAINTENANCE
. Store the appliance in a cool dry place away from direct sunlight.
. Make sure both the gas and the appliance are turned off before changing
the battery. Please refer to the process of inserting the battery.
. Protect your appliance with the cover when not in use.
. The propane cylinder must be disconnected and stored outdoors before
the appliance can be stored indoors.
. Use manufacturer approved or supplied replacement parts and
accessories only.
. Please contact the manufacturer for information regarding replacement
hoses, thermocouples, ignitors, lava rocks, ceramic logs, etc.
23
Publicité
