Human Touch Circa ZG Mode D'emploi Et D'entretien page 4

get ready
UNPACK THE BOX
Chair Body
Head Pillow Power Adapter
PLACE THE CHAIR
1. Consider the following when choosing a chair location:
• Place the chair on a flat, level, carpeted surface to prevent damage to the floor and minimize chair
motor noise.
• Choose a location that is not exposed to direct sunlight for extended periods, to prevent upholstery fading.
• Allow at least a 22-inch clearance behind the chair and a 15-inch clearance in front of it (Fig.1).
22"
Clearance
humantouch.com
Chair base Connecting
Shaft
Power Adapter
Power Supply
Extension Cord
15"
Clearance
Fig.1
4
Your Human Touch Circa ZG Chair
assembly. Just attach the chair body to the base, connect
the power supply, place the head pillow, and you're done!
ASSEMBLE THE CHAIR
1. To avoid scratching the chair, choose a carpeted location or place a clean blanket on the floor for assembly.
2. Place the front of the chair body on the floor, then tip it forward until the headrest reaches the floor (Fig.2).
3. Slide the small end of the connecting shaft into the receptacle on the bottom of the chair body (Fig.2).
Small end of the
connecting shaft
Fig.2
4. Install the chair base onto the large end of the connecting shaft, aligning the arrows, aligning the arrows (Fig.3).
Aligning
the arrows
requires some simple
Larg end of the
connecting shaft
Chair base
Fig.3
5 5