Publicité
8
All manuals and user guides at all-guides.com
7.
8.
9.
10. Locate the POLAR RECEIVER (#16). Slide the FOAM
11. Locate the FRONT and BACK MONOCOLUMN COVERS
12. Place the FRONT MONOCOLUMN COVER (#5) on the
13. Locate one FRONT ROCKER COVER (#13) and one
Attach the 4-PIN (4P), 3-PIN (3P), and 16-PIN (16P) CON-
NECTORS to the corresponding JACKS on the back of the
CONSOLE ASSEMBLY (#4).
Feed any excess WIRE HARNESS (E) down into the
CONSOLE SUPPORT ASSEMBLY (#7). Secure the CON-
SOLE ASSEMBLY (#4) to the CONSOLE SUPPORT
ASSEMBLY using four PHILLIPS PAN HEAD SCREWS
(#2). Tighten the SCREWS securely.
CAUTION: Do not over-tighten the PHILLIPS HEAD PAN
SCREWS (#2).
CAUTION: Be careful not to pinch the WIRE HARNESS
(E) when assembling the CONSOLE ASSEMBLY (#4) to
the CONSOLE SUPPORT ASSEMBLY (#7).
Locate and install the CONSOLE SUPPORT CAP (#19)
onto the CONSOLE SUPPORT ASSEMBLY (#7) as
shown.
ISOLATOR (#15) over the POLAR RECEIVER. Remove
the POLAR RECEIVER JACK (G) from the tape and plug
the POLAR RECEIVER into the POLAR RECEIVER JACK.
(#5 & #6). With the WIRE positioned on top, carefully
insert the POLAR RECEIVER (#16) between the vertical
ribs located inside the BACK MONOCOLUMN COVER
(#6).
Place the BACK MONOCOLUMN COVER (#6) over the
PIVOT SHAFT (H) at the top of the MONOCOLUMN (f).
NOTE: The POLAR RECEIVER WIRE must be positioned
on top when inserted into the REAR MONOCOLUMN
COVER (#6).
opposite side of the BACK MONOCOLUMN COVER (#6)
to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT
ASSEMBLY MOUNTING SCREWS. Interlock the top tabs
and use two PHILLIPS PAN HEAD SCREWS (#3) to
secure the bottoms of MONOCOLUMN COVERS together.
Tighten the SCREWS securely.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD
SCREWS (#3).
BACK ROCKER COVER (#14). Position the FRONT
ROCKER COVER over the user side of the left end of the
PIVOT SHAFT (H) (as shown) making sure that it inter-
locks with the MONOCOLUMN COVERS (#5 & #6). Place
the BACK ROCKER COVER over the opposite side of the
left end of the PIVOT SHAFT in the same manner. Secure
the COVERS using three PHILLIPS PAN HEAD SCREWS
(#3). Repeat the procedure reversing front and back for the
user right end of the PIVOT SHAFT.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD
SCREWS (#3).
Publicité
