2. SAFETY INSTRUCTIONS
caused by the jamming by securely holding the drill with both hands.
As this is a very powerful drill these forces are significant.
L. NEVER Start the drill with the core or drill jammed in position.
M. DO NOT stretch to hold the drill. Do not drill above shoulder height
or below Knee height, as the drill cannot be securely held.
N.Never drill holes that are above the declared maximum size in
the manual.
O. Double check that the accessories and attachments are properly
fixed. A short-time testing running in no-load condition will be helpful
to identify the problems.
P. The drill bit, chuck and the work piece can be very hot while
working. Do not touch them before they have cooled down.
Q. Ensure that the air vents are always unobstructed and clear.
Clean them if necessary with a soft brush. Blocked air vents may lead to
overheating and damage the product.
R. Switch off the power tool immediately when the drill bit jams.
Be prepared for high reaction torque that can cause kickback. The drill
bit jams when: the power tool is subject to overload or it becomes
wedged in the workpiece. Switch the power tool off. Loosen the drill bit.
S. Switch the product off immediately if you are disturbed while
working by other people entering the working area. Always let
the product come to complete stop before putting it down.
T. Do not overwork yourself. Take regular breaks to ensure you can
concentrate on the work and have full control over the product.
U. Only use the battery/charger specified in the technical
specification. Read all safety warnings, instructions, illustrations and
specifications provided with the charger and battery pack.
VIBRATION AND NOISE REDUCTION
To reduce the impact of noise and vibration emission, limit the
time of operation, use low-vibration and low-noise operating
modes as well as wear personal protective equipment.
Take the following points into account to minimize the vibration and noise
FR
FR
ES
ES
PT
PT
IT
IT
EL
EL
PL
PL
RU
RU
UA
KZ
KZ
UA
RO
RO
BR
BR
EN
EN
319