Publicité
Les langues disponibles
Les langues disponibles
8
Product no. 043-2371-2 | Contact us: 1-855-803-9313
1. DISPENSING COLD WATER
2. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This water dispenser left the factory with the cold water temperature control factory "default
setting" positioned for "Energy Star" compliance (identified in diagram at right). This setting will deliver
cold water temperatures between 4–8°C (39–46°F). The cold water temperature can be adjusted,
(using a flat screwdriver) by rotating the adjustment screw clockwise or counter-clockwise between
"Min" (cool) and "Max" (colder) until the desired temperature is reached.
NOTE: Any change/adjustment to the cold water temperature control may
affect Energy Star efficiency.
3. DISPENSING HOT WATER
Important:
that controls activation/operation of the hot water tank heating system. If no water is present and/or low water
levels are detected inside the internal water reservoir, activation/operation of the hot water heating system is
not possible. Likewise, if the hot water heating system is operational and water is being drawn simultaneously
causing internal water levels to drop below the established minimum level set point, hot water tank operation is
automatically suspended. To reactivate the hot water heating system, you only need to replenish the water supply
and heating will resume automatically.
TEMP
Min.
Max.
COLD WATER
WARNING: Hot water temperatures can reach 94˚C / 201˚F and can cause severe scalding. Never let
children dispense water without direct adult supervision.
All manuals and user guides at all-guides.com
1
Your Master Chef™ water dispenser is designed with a special safety feature (low water level sensor)
Operation of the cold water system is not affected by this safety feature.
1
2
3
NOTE: The lower front panel must be installed otherwise hot water
heating is not possible.
2
3
ENERGY STAR FACTORY
DEFAULT SETTING
TEMP
Min.
Min
Max.
Max
COLD WATER
Publicité
