Publicité
Les langues disponibles
Les langues disponibles
Problem
Possible Cause
Water dispenser
Drain cap and silicone seal are not secure.
is leaking
Water is not hot or cold
All the water in the tank has been used.
enough
The unit is unplugged.
Hot water power switch located at the back of
the unit is not activated.
The circuit breaker in your home is tripped or
the fuse has blown.
Temperature limit tripped.
Lower front panel is not installed.
Cold water control needs to be adjusted.
Water dispenser is not
Empty water bottle.
dispensing water
Mineral deposits clogging tanks.
Possible air pocket.
Child safety lock (hot water) not activated.
Water dispenser is noisy
Water pump makes noise as it fills the tank.
Water dispenser is uneven.
NOTE: Do not return this product to the store. For questions on operation, assembly or parts, please contact
Customer Service at 1-855-803-9313 and ask for assistance.
All manuals and user guides at all-guides.com
Suggested Solution
Ensure seal is secure in drain plug and tighten
drain cap.
Replace with full bottle and wait for water to
cool and heat.
Adjust the cold water temperature control to a
colder setting.
Plug it into the outlet.
Activate red "on/off" switch.
Reset the breaker or replace the fuse.
Allow the temperature of the hot water tank
to cool for approximately 15-30 minutes.
The temperature limit switch will re-set
automatically.
The lower front panel must always be installed/
positioned on the unit for proper operation.
Adjust control between Min. (cool) and Max.
(colder) levels to achieve desired temperature.
Replace with full bottle.
See Cleaning the Reservoirs.
Push down the dispenser buttons to prime the
unit.
Activate child safety lock.
This is normal.
Make sure the dispenser is on an even surface
that can support its full weight.
11
TM
Publicité
