Final Assembly; Changing The Battery; Frequently Asked Questions; Technical Data - Marmitek SD10 Mode D'emploi

10 FINAL ASSEMBLY

The lower section of the smoke detector must be attached to the bracket already mounted on
the ceiling and turned clockwise to the stop position.

11 CHANGING THE BATTERY

When the battery of the SD10 is almost empty, the SD10 will indicate this by beeping every 30
to 40 seconds. The sensor will continue beeping for a maximum of 7 days. Please change the
battery immediately on hearing the signal.

12 FREQUENTLY ASKED QUESTIONS

Question: Does the siren of the smoke detector also go off if an alarm is triggered?
Answer: No. The siren in the smoke detector cannot be triggered via the alarm system. It will
only go off when it detects fire/smoke.
Question: How many SD10 smoke detectors can I register?
Answer: Every SD10 is registered at the same address. There is no maximum number of smoke
detectors.
Question: Can the alarm that indicates the battery is nearly empty be switched off?
Answer: No, because of safety considerations this signal cannot be switched off.
Question: Does every SD10 take up the place of a remote control when it is registered?
Answer: No, only the first SD10 you register will take up the place of a KR21. The other SD10s
are registered at the same address.
Any questions?
Visit www.marmitek.com > Customer Service for the latest list of Frequently Asked Questions.

13 TECHNICAL DATA

Frequency:
Range:
Alarm:
Power supply:
Operating temperature:
Air humidity:
8
433,92 MHz
Up to 30 meters.
The range is up to 10 meters in combination with the
HomeGuard MS8000.
85 dB
9V block battery, Alkaline-type
10 to 37 degrees (Celsius)
< 95% rel. air humidity
MARMITEK