Table Des Matières; General Information And Function; Intended Use - Marmitek SD10 Mode D'emploi

WIRELESS SMOKE DETECTOR SD10 OWNER'S MANUAL
For use with Marmitek security systems of the types:
• SafeGuard
• TotalGuard
• HomeGuard MS8000
• Security System MS9470, MS9770, MS9970
• Security System Protector 28
• Home Automation Controller SC2200, SC2700, SC2800, SC9000
Please read these instructions carefully and completely before initial activation; they contain
information for the correct installation of this wireless smoke alarm.
1. General and function
2. Intended use
3. Safety- and maintenance- references
4. Installation places
5. Installation
6. Registering the smoke detector with the SC9000 base station of the SafeGuard / TotalGuard 5
7. Registering the smoke detector with the base stations of the types
MS9470, MS9770, MS9970, SC2200, SC2700, SC2800, Protector 28
8. Registering the smoke detector with the base station of the type Homeguard MS8000
9. Changing the address of the smoke detector
10. Final assembly
11. Changing the battery
12. Frequently Asked Questions
13. Technical data

1 GENERAL INFORMATION AND FUNCTION

The smoke detector can detect incipient low temperature fires and open fires with smoke
development and can be installed in any room. The smoke detector operates by the optical
principle. There are no radioactive substances in this detector.
The smoke detector incorporates the following features:
• It monitors rooms for the development of smoke.
• It has an integrated signal transmitter.
• Your Marmitek Alarm System dials out, even if your security system is not armed.

2 INTENDED USE

The radio smoke detector is intended for the detection of smoke in interiors by the use of
optical and acoustic warnings, as well as wireless transmission over distances of up to 30
meters. In combination with the HomeGuard MS8000 the range is up to 10 meters. Range may
vary due to battery and temperature conditions.
SD10
3
4
4
4
5
6
6
7
8
8
8
8
3