Installation; Registering The Smoke Detector With The Sc9000 Base Station Of The Safeguard / Totalguard - Marmitek SD10 Mode D'emploi

Ensure that the smoke detector is not installed directly on or near large metal objects as they
can affect the radio range.
Before installing the SD10 smoke detector on your ceiling or the wall, ensure that the SD10 is
within range of your Marmitek security system. You can test this by pushing the test button of
the SD10. The Marmitek security system should now be triggered and will dial the pre-
programmed telephone numbers.
In the case of range problems, choose a different location for your SD10 smoke detector.
Moving the SD10 just a few centimetres can make a big difference in range.
To avoid false alarms, do not install the SD10 smoke detector in your kitchen, garage, in dusty
places, in places with a higher than average air flow (near ventilation, open windows), near
metal and in places where the temperature is below 10˚C or above 37˚C.

5 INSTALLATION

Please follow these steps to install the Marmitek smoke detector:
• Do not insert the battery at this stage (9V). Please follow the steps of the next chapter
before you insert the battery. The smoke detector will not operate until you insert the
battery properly.
• Remove the mounting bracket from your unit by rotating it counter-clockwise.
• In each of the keyhole slots, draw a mark to locate a mounting plug and screw.
• Remove the bracket.
• Drill two holes at the marks and insert plastic wall plugs. Ensure that the detector does not
get any plaster dust on it when you drill the holes for mounting.
• Attach the bracket to the wall using the two screws and plastic wall plugs (supplied)
• Line up the slot of the bracket and the detector. Push the detector onto the mounting
bracket and turn it clockwise to fix it into place. Pull outward on the detector to make sure
it is securely attached to the mounting bracket.
6. REGISTERING THE SMOKE DETECTOR WITH THE SC9000
BASE STATION OF THE SAFEGUARD / TOTALGUARD
Carry out the following steps:
1. To access the menu, press the menu
PIN'.
2. Enter your 4-digit PIN code (factory setting 0000). For every digit entered, a * will appear on
the display.
3. When the PIN code has been entered correctly, the word 'INSTALL' will show up on the
display.
4. Press OK.
5. Insert the battery into the smoke detector (see the user manual of the smoke detector for
more information). The console will beep to confirm. The display will read 'RMOT x SET'.
SD10
or menu button. The display will now read 'ENTER
5