Changing The Address Of The Smoke Detector - Marmitek SD10 Mode D'emploi

3. Press "1" on the keyboard of the HomeGuard MS8000: one high tone is given to confirm.
4. Place the battery (9V) in the battery holder of the smoke detector. (Ensure that the polarity is
correct.) The smoke alarm will send a radio signal to the base station: The LED on the sensor
will illuminate briefly, and the base station will emit a short signal tone to confirm.
How to install the battery:
• The smoke detector requires an alkaline battery
• Match terminals on the end(s) of the battery with opposite terminal connectors on the
detector. Be sure to insert the alkaline battery in the position shown on the detector.
• When terminals are properly matched, push the battery firmly in place until it snaps and
cannot be shaken loose.
5. Even if you are using more than one smoke detector you only have to register the first one.
6. Press any button on your HomeGuard MS8000 keyboard to finalize the registration
procedure. One short low tone will be given and the green indicator stops flashing.
Now the smoke detector is registered and ready for use.
You can test your system by pressing the test key on the smoke detector for more than 2 seconds.
In the case of a fire the smoke detector sends the alarm signal to the Marmitek alarm
installation (it does not matter whether the HomeGuard MS8000 is set to arm or disarm. The
alarm will be triggered in both cases!).
Your HomeGuard MS8000 will dial the pre-programmed telephone numbers and its internal
siren will sound (depending on your settings).

9 CHANGING THE ADDRESS OF THE SMOKE DETECTOR

The Marmitek SD10 supports different addresses for each sensor. You will need to use this
feature when your neighbour also uses a Marmitek security system combined with one or more
SD10 smoke detectors.
Changing the address of the sensor:
The default address of your sensor is 1. Every key-press of the test-key increases the address of
the sensor by 1. This only works immediately after the power-connection between the sensor
and its battery is established.
To change the address, press the test-key during the first 2 seconds after connecting the battery.
Each time you change the address of the sensor you will have to register this sensor again in
your Marmitek base station (please read the corresponding chapter in this user manual (chapter
6 or 7 depending on your Marmitek security system). The smoke detector has 250 different
addresses.
SD10 7