KitchenAid KFP0922 Instructions page 12

Setting Up Your Food Processor
Installing the Multipurpose
Blade or Dough Blade
IMPORTANT: The multipurpose blade
and dough blade can only be used with
the work bowl.
1. Place the blade on the power shaft.
2. Rotate the blade so it falls into place on
the power shaft.
3. Push to lock: Press down firmly on the
multipurpose blade until it is down as
far as it will go. The multipurpose blade
features an internal seal that fits tightly
over the center of the work bowl.
4. Install the work bowl cover, being sure
it locks into place. See "Attaching the
Work Bowl Cover" section.
12
Installing the Mini-Bowl and
Mini-Blade
1. Place the mini-bowl inside the work bowl
over the power shaft. Rotate the mini-
bowl until the tabs on the top edge of the
bowl drops into the indents on the top of
the work bowl.
2. Insert the mini-blade, and place on the
power shaft. It may be necessary to rotate
the blade until it falls into place. Press
down firmly to lock it into place.
3. Install the work bowl cover, being sure it
locks into place.
4. To remove the mini-bowl after processing,
remove the mini-blade by pulling straight
up on the cap. Then lift the bowl straight
up and out, using the two finger grips
located along the top edge of the bowl.