Publicité
Les langues disponibles
Les langues disponibles
Installation
Notes:
• When you have locked TV channels while initiating autoprogram, a message appears asking to enter your PIN code in order to complete autoprogramming.
• When interrupted, the updated channel information is retained as well as the not yet updated old channel information.
• Background autoprogramming occurs only when the TV is turned on.
• Channel information of an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequencies and update information.
• Weak channel installation : This allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that
channel. (See Installation menu, Weak channel installation, p. 9.)
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
English_DFU_37131.indd 8
All manuals and user guides at all-guides.com
Select the menu language
Press the
&
Use the cursor down to select
é
Use the cursor right to enter the Installation menu.
"
Select
Language
'
right.
Select your language with the cursor up/down and press the
(
confirm you selection.
Proceed with the Installation menu.
§
Store TV channels
Select
Autoprogram
&
Use the cursor right to enter the Autoprogram menu.
é
Press the
"
Select
Cable
'
When
Antenna
search for antenna TV (NTSC and ATSC) channels available in your local
area.
When
Cable
and will search for cable TV (NTSC, ATSC, QAM modulated) channels
available in your area.
Make sure that registration with your cable TV provider and connection of
equipment are completed.
Press the green button "
(
Note: All channels must be unlocked in order to autoprogram. If requested, enter
your PIN code to unlock all channels. See Menu preferences in the Settings, TV
menu, p. 14.
Press the green button "
§
The menu screen disappears and the progress of autoprogramming is
displayed. The progress bar indicates the number of analog and digital TV
channels found.
When Autoprogramming is complete, a message appears confirming
the completion. Press the red button "Finish" and the TV returns to the
Installation menu.
8
button on the remote control.
MENU
Installation
and enter the list of available languages with the cursor
in the Installation menu.
button.
OK
or
in the Installation mode.
Antenna
is selected, the TV will detect antenna signals and will
is selected, the TV will detect cable company supplied signals
Next"
on the remote control.
to start autoprogramming.
Start"
in the Settings menu.
button to
OK
2006-03-29 6:30:51 PM
Publicité
