Power Fist 8340515 Mode D'emploi page 7

8340515
CHANGING THE BATTERY PACK
A Battery Pack
B Battery Charger
See Figure 3
1. Make sure the tool's trigger switch is released (in the OFF position) and the
trigger lock switch is in the locked (neutral) position.
2. Remove the battery pack.
3. Plug the charger into a 120v electrical outlet.
4. Insert the battery into the charger. While in use, a charging indicator light on the
charger will turn on to show that the battery is being properly charged.
5. After approximately one hour check if the battery is finished charging. The red LED light indicating the
battery is being charged should turn off and the green LED light indicating that the battery is fully
charged should turn on.
6. Once the battery is fully charged, remove the battery from the charger.
BATTERY CHARGE INDICATOR LIGHTS
Your drill is equipped with charge indicator lights.
To check the battery condition, press and hold the button on top of the cordless drill.
• When all three lights are illuminated, this indicates that the battery pack is fully charged.
• When two lights are illuminated, this indicates that the battery is partially charged.
• When only one light is illuminated, this indicates the battery pack is slightly charged.
• When no lights are illuminated, the battery pack is completely discharged.
FORWARD / REVERSE AND TRIGGER LOCK SWITCH
Be sure the trigger is released when changing the position of the forward / reverse and trigger lock switch. Always
store the tool in the locked position.
A Reverse
B Lock (neutral)
C Forward
See Figure 4
1. To select forward rotation, press the trigger lock from right to left, flat
against the drill body.
2. To select reverse, press the trigger lock switch in the opposite direction.
3. The center position (neutral) locks the tool.
Visit www.princessauto.com for more information
Powerfist 18v Ni-Cd 3/8 in. Cordless Drill V 2.9
7