Power Fist 8340515 Mode D'emploi page 10

V 2.9
MAINTENANCE
Before making any adjustments or changing any accessory, turn off the tool and unplug it from its power source.
1. Check for damaged parts. Before using any tool, any part that appears to be damaged should be carefully
checked to determine that it would operate properly and perform its intended functions. Check for alignment
and binding of moving parts, for broken parts or mounting fixtures, or for any other condition that may affect
proper operation. Any part that is damaged should be repaired or replaced by a qualified technician.
2. When servicing, use only identical replacement parts. Only use accessories intended for use with this tool.
Replace damaged parts immediately.
3. Keep the tool clean. Wipe the tool with a clean cloth and periodically blow out all areas with compressed air.
If compressed air is not available, use a brush to remove dust from all areas. Do not use harsh chemicals or
solvents to clean the tool. These chemicals could seriously damage the plastic housing.
4. Regularly inspect all mountings and screws to ensure tightness. Should any screws become loose,
tighten immediately.
5. If repairs are required, bring your tool to an authorized service center.
6. Keep the vent passage clear from dirt. Clean off the accumulated dust and oil dirt periodically.
7. During normal operation, if anything happens, the power supply should be cut off at once and the tool
should be checked and repaired.
8. Clean the tool after each use.
CAUTION! Only a qualified service technician should repair the tool.
DISPOSING OF THE TOOL
1. If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate
recycling facility.
2. Do not incinerate battery packs. Battery packs may explode when exposed to high heat.
10
Powerfist 18v Ni-Cd 3/8 in. Cordless Drill
For technical questions call 1-800-665-8685
8340515